Ingenico eN-Crypt 2100™

IMPORTANT Verify that eN-Command OS: 5.25 is displayed on the Ingenico eN-Crypt 2100 screen on boot up.

Change the settings of the Ingenico eN-Crypt 2100 by performing these steps:

1. Restart the device by unplugging and replugging in the power cord.

2. Press the F1 button immediately to bring up the Menu.

3. Press 1 for Setup.

4. Press 1 for Host Port.

5. Press 1=EIA-232 for RS-232 setting.

Press 1 for Baud setting – Press 1=Change to scroll through setting options. Press 0=Exit when finished.
Press 2 for Parity setting – Press 1=Change to scroll through setting options. Press 0=Exit when finished.
Press 3 for Data Bits setting – Press 1=Change to scroll through setting options. Press 0=Exit when finished.

6. Press 0 to exit back a screen at any time.

NOTE Please note that all settings pertain to operating system 5.25.